Publicité
Les langues disponibles
Les langues disponibles
English
Fig. C
4. Test to see if the dust extractor is properly installed on
the rotary hammer:
a. Install the dust extractor.
b. Start your drilling operation and stop after 1/4"
(6 mm).
c. Lift the tool and check if the dust extraction is
working. There should be no debris.
d. If the dust extractor is operating properly continue
your work.
To Remove the Dust Extraction System
(Fig. B)
To remove the dust extraction system, pull downwards
on the two extractor base release buttons
rotary hammer off the dust extraction system.
The side handle must be removed to store the dust
extractor properly in the kitbox.
Attaching and Removing the Dust
Extraction System to the D25333
To Attach the Dust Extraction System
(Fig. A, D, E)
WARNING: To reduce the risk of personal injury,
ALWAYS operate the tool with the side handle
properly installed and securely tightened. Failure
to do so may result in the side handle slipping during
tool operation and subsequent loss of control. Hold
tool with both hands to maximize control.
To use the dust extractor with the D25333 you will first need
to install the corded tool adapter
extraction head.
1. Remove the drill bit, and the depth adjustment rod, if
attached to the rotary hammer.
2. Install the corded dust extraction head on the
dust extractor.
3. Ensure the base release buttons
are in the unlocked position before attempting to fit the
dust extraction system to the rotary hammer.
4. Attach the adapter by sliding it forward on the grooves
as shown in Fig. D. The adapter will click in place when
properly installed on the dust extractor.
4
13
14
2
and slide the
11
and the corded dust
are depressed and
2
Fig. D
11
5. Insert hammer into the extractor, ensuring that both
the support grooves
15
hammer to the dust extractor. The base release buttons
will click into the locked position when hammer is
properly seated in the extractor.
nOTE: The hammer will not slide into the dust extractor
if the base release buttons are in the locked position.
Fig. E
2
6. Test to see if the dust extractor is properly installed on
the rotary hammer:
a. Install the dust extractor.
b. Start your drilling operation and stop after 1/4"
(6 mm).
c. Lift the tool and check if the dust extraction is
working. There should be no debris.
d. If the dust extractor is operating properly continue
your work.
To Remove the Dust Extraction System
(Fig. E)
To remove the dust extraction system, pull downwards
on the two extractor base release buttons
rotary hammer off the dust extraction system.
The side handle must be removed to store the dust
extractor properly in the kitbox.
OPERATION
WARNING: To reduce the risk of serious personal
injury, turn off tool and disconnect the tool
from the power source before making any
adjustments or removing/installing attachments
or accessories. An accidental start-up can
cause injury.
WARNING: For your own safety, read the tool
instruction manual before using any accessory.
Failure to heed these warnings may result in personal
injury and serious damage to the tool and the
accessory. When servicing this tool, use only identical
replacement parts.
are aligned on the sides of the
15
2
and slide the
Publicité
