Hitachi H 30PV Instructions De Sécurité Et Mode D'emploi page 10

English
CAUTION: To prevent accidents, make
sure to turn the switch off and
disconnect the plug from the
receptacle.
NOTE:
When using tools such as bull points,
cutters, etc., make sure to use the genuine
parts designated by our company.
1. Installing Tools
CAUTION
To prevent accidents, make sure to turn
the switch off and disconnect the plug
from the receptacle.
NOTE:
When using tools such as bull points,
cutters, etc., make sure to use the genuine
parts designated by our company.
(1) Clean the shank portion of the tool.
(2) Insert the tool in a twisting manner into
the tool holder until it latches itself. (Fig.
2, 3)
(3) Check the latching by pulling on the tool.
(Fig. 4)
2. Deciding Working Position of Tool
The tool can be turned every 30 degrees
and can be fixed at the position of 12
steps.
(1) As shown in Fig. 5, grip (B) is turned 60
degrees in the direction of A, the blade
angle can be changed freely to any desired
position. (Fig. 6) is turned 60 degrees in
the direction of A.
(2) As shown in Fig. 7, return grip (B) in the
direction of A, and make sure that it is
locked completely.
3. Removing Tool
As shown in Fig. 8, pull front cap in the
direction of A, and pull out the tool. (Fig.
9)
10
ASSEMBLY
Tool
Shank
Front
Cap
Front Cap
Fig. 2
Fig. 4
A
Grip (A)
Fig. 6
A
Fig. 8
Fig. 3
A
Grip (B)
Fig. 5
A
Grip (B)
Fig. 7
Fig. 9