Adjusting The Machine Based On Tube Diameter - AXXAIR SATO-40E41 Mode D'emploi

INNOVATIVE ORBITAL SOLUTIONS
7.

Adjusting the machine based on tube diameter:

Final position:
See the various
possibilities of torch
adjustment in the pages
of following ones
Electrode axial
control
Clamped tube.
The electrode axis aimed at the centre of the pipe.
H = distance between the tube and the electrode
Electrode positioning with reference to the weld joint.
Note: For accurate adjustment, set several parameters simultaneously and
repeat the operation if necessary.
IMPORTANT: Arc height adjustment should be carried out with care. In fact, most welded pipes have
a slight ovalisation deformity. Depending on the selected tube, make sure the adjustment is done
properly so that the electrode does come into contact with the weld pool. If in doubt, increase the tube-
electrode distance by a few tenths. The standard adjustment is the wall thickness.
It is easier to make this adjustment more accurately using a spacer between the pipe and the flat end
of the electrode.
Join experience
0
The electrode
axis is aimed
at the centre of
the tube
Torch arm indexing
SAS au capital de 135 720 € - RCS Romans B414 581 363 – Code APE 2841 Z – Siret 414 581 363 00028 – TVA FR13414 581 363
330B Route de Portes Les Valence - ZI Les Bosses - 26800 Etoile sur Rhône
Tél: +33 475 575 070 - Fax: +33 475 575 080 - commerce@axxair.com - www.axxair.com
- 23 -
ENGLISH
Hose support
Hose fixation
system