Installing The Motor On The Machine; Cutting Parameters - AXXAIR CC122 Notice Originale

INNOVATIVE ORBITAL SOLUTIONS

8. Installing the motor on the machine:

WARNING: Clean all support surfaces well before installing the cutting head on the motor's supporting
plate. Using the brush provided, clean the surface of the tool supporting plate as well as those of the
cutting heads. The quality of the cuts depends on the geometry of these support surfaces.
The motor is installed on the tool supporting plate by sliding it into the slot provided for that purpose.
-
The motor's positioning is assured by two preinstalled plates which ensure that the angle head
-
adheres to the support surface of the tool supporting plate.

9. Cutting parameters:

A CC type cutting machine, having the correct cutting parameters and
the proper saw blade, guarantees a quality cut.
There are two cutting parameters.
- The rotation speed of the cutting tool (RPM), expressed as revolutions per minute.
The speed with which the tool advances (A), expressed in meters per minute.
-
RPM can be regulated either with the variable speed control on the electric cutting motors or by varying
the input air pressure on a pneumatic motor. Consult the table on page 3.
The speed with which the tool advances (A) is controlled by the operator by adjusting the rotation speed
of the advance crank handle, or can be automated with an electric or pneumatic motor (consult the
accessories catalogue).
Rotation Speed RPM:
The rotation speed RPM is found using the formula:
Vc = the tool's cutting speed in m/min
D = the tool's diameter in mm
From 50 to 110 (carbon/stainless steel)
Join experience
ENGLISH
RPM = (1000 x Vc) / (3.14 x D)
Hardness of the material in kg/mm²
From 0 to 50 (carbon steel)
Over 110 (Stainless steel)
SAS au capital de 135 720 € - RCS Romans B414 581 363 – Code APE 2841 Z – Siret 414 581 363 00028 – TVA FR13414 581 363
Vc in m/min
From 25 to 35
From 18 to 25
From 12 to 18
330B Route de Portes Les Valence - ZI Les Bosses - 26800 Etoile sur Rhône
Tél: +33 475 575 070 - Fax: +33 475 575 080 - commerce@axxair.com - www.axxair.com
- 17 -