Installing The Clamping Jaws - AXXAIR DC115-AM1 Mode D'emploi

English

4.2 Installing the clamping jaws

 Check the outside diameter of the tube to be machined.
 Choose the jaws depending on the diameter of the tube to be machined.
 Position the bottom jaw and then tighten screw IDIN912-M6x20 (tightening torque =
7.4Nm, 5.0mm Allen key supplied).

For the upper jaw, screw the nose of the raise and lower screw into the bore (so that
it rests against the upper jaw), then tighten screw IDIN912-M6x50 (tightening torque
= 7.4Nm, 5.0mm Allen key supplied).
Attention, if the jaw touches the inner face of the bore, the jaw tightening
system will be locked.
- 21 -
Z.I. Les Bosses
F-26800 ETOILE-SUR-RHONE
www.axxair.com