Van Berkel International HOME LINE 200 Manuel D'instructions page 15

Troubleshooting
PROBLEM
The machine does not start when
the on button is pressed
When the start button is pressed,
the machine starts but
the operation indicator light
does not switch on
When the stop button is pressed,
the machine does not stop
Excessive resistance to
sliding component movement
(product holder, carriage).
PROBABLE CAUSE
No power or defective
control circuit
Defective indicator light
Defective control circuit
Sliding guide lubrication
not performed
periodically
15
REMEDY
Check if the plug has been
inserted correctly. Contact a
Service Centre if the problem
persists
Do not use the machine with
the indicator light off. Contact a
service centre
Immediately stop the machine by
pulling the plug out of the socket
and immediately contact a service
centre
Perform periodic
lubrication