Reinstall All Services; Test Reception; Restore Factory Settings - Philips DTR 300/00 Mode D'emploi

DTR 300 sans esp_140205.qxd
screen.The Puck moves to the Store button.
- Press <OK> to store the new services.
- Alternatively, scroll down to the Discard button and press
<OK> to discard the new services.
Note: before storing/discarding the services found, you may view
the search results for TV/Radio channels and other
services by scrolling up to the respective item.
u
- Press to exit the screen and return to the Service setup
sub-menu, or press the blue colour button to exit the menu.

7.3.2.2 Reinstall all services

This feature is used to reinstall all services, overwriting the
previous service settings.
i
- Press to enable the reinstallation feature.You are then
prompted to confirm you want to reinstall al services.
- Press <OK>, then proceed as described above.
7.3.3

Test reception

This feature is used to help you position your antenna and
check the availability of signals on specific RF channels.
The selection is on RF channel.
i
- Press to access the list of RF channels.
- Scroll up or down the list to the RF channel you want to select.
- Press <OK> to view the signal quality and strength for the
selected channel.
- If need be, move your antenna to obtain an adequate
signal.When the signal is good enough, the name of the
corresponding network is displayed.
i
- Press again to return the list of available RF channels
and proceed as described above to check the signal quality
and strength for another RF channel.
Note: if you cannot obtain an adequate signal, refer to the
troubleshooting guide.
u
- Press to exit the screen and return to the Service lists
sub-menu, or press the blue colour button to exit the menu.
7.3.4

Restore factory settings

To restore the receiver factory settings:
14/02/05 16:16 Page 27
CHANGE THE SETTINGS OF YOUR RECEIVER 27