Vcr; Channel Banner - Philips DTR 300/00 Mode D'emploi

DTR 300 sans esp_140205.qxd
24 CHANGE THE SETTINGS OF YOUR RECEIVER
14/02/05 16:16 Page 24
7.2.3.1 TV
This item is used to select the format of the output signal
for the TV and VCR SCART sockets.
- Scroll to the setting you want to change.
The corresponding values are displayed on the right-hand
side of the screen.
i
- Press the button to access the available values:
• Video Output: RGB, CVBS-PAL, CVBS-SECAM, or Y/C.
RGB is the default and recommended setting.
• Audio Output: Stereo or Mono
• Screen format: select the aspect ratio of the video
output that best suits your TV.
Note: it is recommended to use the RGB setting to get the best
video quality on the TV screen. If you use a video projector
instead of a TV set, the Y/C setting is recommended (refer to
paragraph 4.3 for connection and installation).

7.2.3.2 VCR

This item is used to select the format of the output signal
for the VCR SCART socket.
- Scroll to the setting you want to change.The
corresponding values are displayed on the right-hand side
of the screen.
i
- Press the button to access the available values:
• Video Output: CVBS-PAL, CVBS-SECAM, or Y/C.
CVBS-PAL is the default and recommended setting.
• Audio Output: Stereo or Mono
• Easy Record: select the control method that suits your
VCR. Refer to paragraph 9.2 and your VCR user
manual.
Note: If you have a S-Video VCR, select the Y/C setting. Please
consult the user manual of your VCR.

7.2.3.3 Channel Banner

This item is used to select the channel banner display
settings.
- Scroll to the setting you want to change.
The corresponding values are displayed on the right-hand
side of the screen.
i
- Press the button to access the available values:
• Duration
• Transparency