Haier ESA415M Guide D'utilisation Et D'entretien page 16

PREPARING THE AIR CONDITIONER cont.: ESA415 / ESA418
1. Measure the width of the window opening. (See Fig.8)
2. Mark the center line on the inside of the windowsill with a pencil. (See Fig.9)
WIDTH OF
WINDOW OPENING
Fig. 8
WIDTH
NOTES AND WARNINGS:
• Be sure your air conditioner does not fall out of the opening during installation or removal.
• A grounded electrical outlet must be within 4 ft. (122 cm) of where the power supply cord
exits the air conditioner.
• Do not block the air discharge or air intake areas on the front panel.
• Do not block the louvers on the outside of the air conditioner.
INSTALL THE CABINET IN THE WINDOW
FOR MODELS: ESA415M
1. Center the cabinet in the windowsill. Make sure to place the cabinet so that it is resting on the
windowsill with a ¼" to ½" downward tilt towards the outside (See Fig. 10). Lower the window
sash behind the front flange of the top channel to hold the unit in place. The bottom channel
must rest behind the window sill.
NOTE: The appearance of your model may differ from the one shown.
Fig. 10
WIDTH
(See Fig.10)
ESA418M
Bottom Channel
Window Sill
HOW TO INSTALL
CENTER LINE
Fig. 9
HEIGHT
WIDTH
CENTER
PAGE 13