Ravelli RBV 8008 Manuel D'utilisation Et D'entretien page 95

1. Unique identification code of the product type:
50018DR00, residential space heating appliance fired by wood pellets
EN 14785:2006
2. Type, batch or serial number or any other element allowing identification of the construction product as required under Art. 11(4):
RBV 8008
3. Intended use or uses of the construction product, in accordance with the applicable harmonised technical specification, as foreseen by the manufacturer:
Residential space heating appliance fired by wood pellets
4. Name, registered trade name or registered trademark and contact address of the manufacturer as required by Art. 11 (5):
Ravelli
Aico S.p.A.
Via A. Kupfer, 31
25036 Palazzolo s/O (Bs) Italia
5. Where applicable, name and contact address of the authorised representative whose mandate covers the tasks specified in Article 12(2):
---
6. System or systems of assessment and verification of constancy of performance of the construction product as set out in Annex V:
System 3, System 4
7. In case of the declaration of performance concerning a construction product covered by a harmonised standard:
The notified laboratory IMQ (NB 0051) performed the determination of the product type on the basis of type testing under system 3 and issued
test report CS19-0039962-01
8. Declared performances:
Harmonized technical specification:
Essential characteristics
Fire safety
Reaction to fire
Distance to combustible materials
Risk of burning fuel falling out
Emission of combustion products
(at 13% of O )
2
Surface temperature
Electrical safety
Cleanability
Maximum operating pressure
Flue gas temperature at nominal heat output
Mechanical resistance(to carry a chimney/flue)
Nominal heat output
Room heating output
Water heating output
Efficiency
9. The performance of the product identified in points 1 and 2 is in conformity with the declared performance in point 8. This declaration of performance
is issued under the sole responsibility of the manufacturer identified in point 4.
Place
DECLARATION OF PERFORMANCE
Declaration of performance according to Regulation (EU) 305/2011
n. : 209CPR13.07
Signed for and on behalf of the manufacturer Claudio Mezzalira, Operation Manager
Palazzolo sull'Oglio
EN 14785:2006
Performance
A1
Minimum distances (mm):
rear = 220
sides = 190
front = 1000
ceiling = --
floor = 300
Pass
Nominal heat output
CO 0,004 %
NOx 84 mg/Nm
3
OGC 2 mg/Nm 3
PM 14,6 mg/Nm 3
Reduced heat output
CO 0,021 %
OGC 4 mg/Nm
3
Pass
Pass
Pass
--
132 °C
NPD
7,7 kW
7,7 kW
--
Ƞ 90,5 % Nominal heat output
Ƞ 93,1 % Reduced heat output
21/06/2019
Date Sign _______________