Lighting And Adjusting The Open Rings; Lighting And Regulating Gas Oven Burner; Mechanical Timer - Lotus PA-78G Instructions Pour L'installation Et L'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

GB

LIGHTING AND ADJUSTING THE OPEN RINGS

On the front panel, above each knob, the burner it corresponds to is indicated by the index
Use a lighter to light the gas: turn the knob to the left, from the "0" position to the
(see figure), hold it down and light the gas.
Keep the knob pressed a few second and then let it go, this lights the pilot.
If the flame goes out you have to repeat the procedure.
By turning the knob round to the
By turning the knob round to the
To switch off, move the knob back into position " 0".

LIGHTING AND REGULATING GAS OVEN BURNER

To light, turn the knob to the left from position "0" to the
keep it pushed down and press the button with the
It is possible to check the flame through the inspection hole on the oven floor (bottom); after a
few seconds, release the knob. If the flame goes out, repeat the operation. Turn the knob into
the position of the desired temperature.
To turn off the oven, turn the knob to the right, into position "0"
Attention! - When the oven is on, the door must not remain open because it could heat and
damage the knobs.
NB: Cookers are provided with an acoustic timing device, able to signal a maximum time of
120 minutes. Turn the knob to the right, positioning on the time desired, between and
including 0 to 120 minutes (see figure); at the end of the set time, the alarm goes off.
IE
IT
CH
position the burner is at maximum
position the burner is at minimum.
symbol until the gas lights.

MECHANICAL TIMER

30
sign
symbol (see figure);

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Pat-78gPaf-78g

Table des Matières