Bosch EasyImpact 12 Notice Originale page 11

OBJ_BUCH-2943-001.book Page 11 Monday, August 22, 2016 2:02 PM
Symbol Meaning
U Rated voltage
n 1 No-load speed (1. gear)
0
n 2 No-load speed (2. gear)
0
n Impact rate
S
M Maximum torque according to ISO 5393
Brickwork
Metal
Wood
Ø Drilling diameter, max.
Ø Max. screw dia.
Chuck clamping range
Weight according to EPTA-Procedure
01:2014
L Sound power level
wA
L Sound pressure level
pA
K Uncertainty
a Vibration total value
h
T Permitted ambient temperature during
1
charging
T Permitted ambient temperature during
2
*
operation and storage
* limited performance at temperatures
<0 °C
Recommended batteries
Recommended chargers
Delivery Scope
Combination cordless drill.
Battery, application tools and other accessories shown or de-
scribed are not part of the standard delivery scope.
A complete overview of accessories can be found in our ac-
cessories program.
Mounting and Operation
The following table indicates the action objectives for mounting and operation of the power tool. The instructions for each action
objective are shown aside. Depending on the type of application, various instruction combinations are required. Observe the
safety instructions.
Action
Removing the battery
Bosch Power Tools
Intended Use
The machine is intended for driving in and loosening screws
as well as for drilling in wood, metal, ceramic and plastic and
for impact drilling in brick, brickwork and masonry.
The light of this power tool is intended to illuminate the power
tool's direct area of working operation and is not suitable for
household room illumination.
Technical Data
The technical data of the machine are listed in the table on
page 161.
Noise/Vibration Information
The measured values of the machine are listed in the table on
page 161.
Sound emission values determined according to
EN 60745-2-1, EN 60745-2-2.
Vibration total values a (triax vector sum) and uncertainty K
h
determined according to EN 60745-2-1, EN 60745-2-2.
The vibration level given in this information sheet has been
measured in accordance with a standardised test given in
EN 60745 and may be used to compare one tool with anoth-
er. It may be used for a preliminary assessment of exposure.
The declared vibration emission level represents the main ap-
plications of the tool. However if the tool is used for different
applications, with different accessories or insertion tools or is
poorly maintained, the vibration emission may differ. This
may significantly increase the exposure level over the total
working period.
An estimation of the level of exposure to vibration should also
take into account the times when the tool is switched off or
when it is running but not actually doing the job. This may sig-
nificantly reduce the exposure level over the total working
period.
Identify additional safety measures to protect the operator
from the effects of vibration such as: maintain the tool and the
accessories, keep the hands warm, organisation of work pat-
terns.
Figure Please observe
1
English | 11
Page
162
1 609 92A 32G | (22.8.16)