Operation - EINHELL GE-CL 36 Li E Mode D'emploi

5.2. Mounting the catch bag (Figs. 10-12)
Hang the hook on the suction tube (Fig. 10) and
on the housing (Fig. 11). Then slip the catch bag
over the socket on the motor housing; it engages
correctly when it makes an audible click (Fig. 12).
5.3. Fitting the handle
Slide the handle (Fig. 14/Item 15) onto the
mounts in the housing as far as the stop. Then
fasten the handle on both sides with one screw
on each side (Fig. 14/Item 13).
5.4. Fitting the additional handle
Remove the star screw (Fig. 15/Item 16), fi t the
handle (Fig. 15/Item 3) to the mount and secure
the handle in the required position with the star
screw.
5.5. Fitting the harness
Open the knurled screw (Fig. 16/Item 17), feed
the belt strap (Fig. 16/Item 4) through the opening
and close the knurled screw again.
5.6 Fitting the battery (Fig. 17)
Press the pushlock button (Fig. 17/Item 18) of
the rechargeable battery as shown in Fig. 17 and
push the battery into the battery mount provided.
When the battery is positioned as in Fig. 9, make
sure that the pushlock button latches in place!
To remove the battery pack, proceed in reverse
order.
Important!
Use only batteries which are charged to the same
level. Never combine full and half-full batteries.
Always charge the two batteries simultaneously.
The equipment's operating time depends on
the battery with the lower charge level. The two
batteries must always be fully charged before use.
Anl_GE_CL_36_Li_E_SPK7_USA.indb 11 Anl_GE_CL_36_Li_E_SPK7_USA.indb 11
EN

6. Operation

6.1. Sizing the strap (Fig. 1)
Size the length of the carrying strap (4) so that
the suction tube just clears the ground. The guide
rollers (9) at the bottom end of the suction tube
will help you to maneuver the suction tube on the
ground.
6.2. Switching on the equipment (Fig. 17)
•
To switch on, press the On/Off switch (5).
•
To switch off, let go of the On/Off switch (5).
6.3 Selecting the mode of operation
6.3.1 Suctioning (Fig. 18)
Turn the lever (Fig. 18/Item 8) to position A. You
can do this both when the equipment is at a
standstill and while it is running.
6.3.2 Blowing (Fig. 18)
•
Turn the lever (Fig. 18/Item 8) to position B.
You can do this both when the equipment is
at a standstill and while it is running.
•
Channel the air stream forward and walk
slowly to blow foliage or garden refuse into a
pile or to clear out hard-to-reach places.
•
Important! Empty the catch bag before
blowing. Otherwise, the material that has
been vacuumed up could drop out.
6.4 Emptying the catch bag (Fig. 1)
Empty the catch bag (7) in good time. With a
nearly full bag, the suction power drops notably.
Organic waste should be composted.
•
Switch off the equipment and remove the
batteries.
•
Open the zipper on the catch bag (7) and
shake out the material.
•
Close the zip on the catch bag (7) again.
6.5 Speed control (Fig. 1)
The device is fi tted with an electronic speed
controller. To use it, turn the speed controller
(Fig. 1/Item 10) into the required position. Use
the device only with the speed which is actually
required and do not let it run at a speed which is
faster than necessary.
6.6 Charging the Li battery pack
The corresponding instructions can be found
in the original operating instructions for your
charger.
- 11 -
25.04.2019 13:50:36 25.04.2019 13:50:36