Emerson Process Management Solu Comp Xmt-A Manuel D'instructions page 95

Xmt-A
Basic setup
Tag
PV Range Values
PV LRV
PV URV
PV
PV % rnge
Device information
Distributor
Model
Dev id
Tag
Date
Write protect
Snsr text
Descriptor
Message
Revision #'s
Detailed setup
Sensors
Oxygen *
pH #
Temperature
Signal condition
LRV
URV
Figure 75. Menu du communicateur 375 connecté à un transmetteur Xmt-A-HT 2/3
Universal rev
Fld dev rev
Software rev
Hardware rev
Oxygen Unit [ppm, ppb, %sat, mmHg, inHg, atm, kPa, mbar, bar] *, *****
Oxygen Sensor [ADO, TRDO, SSDO1, SSDO2] ##
Salinity ###
Pressure Unit [mmHg, inHg, atm, kPa, mbar, bar] ##
Use process pressure for %saturation? [No, Yes] ###
Process pressure (Note: Valid only when process pressure is enabled)
Air cal pressure ## (read only)
Input filter
Sensor SST
Sensor SSS
Dual Range Cal [Disable, Enable] ####
pH Value
pH Comp [Auto, Manual]
Manual pH
Preamp loc [Sensor, Xmtr]
Autocal [Manual, Standard, DIN 19267, Ingold, Merck]
pH Slope
pH SST
pH SSS
pH Zero Offset Limit
pH Diagnostics
Diagnostics [Off, On]
GFH
GFL
Imped Comp [Off, On]
Temp Comp [Auto, Manual]
Man. Temp
Temp unit [ºC, ºF]
Temp Snsr
Utilisation des communicateurs 275 & 375
Nota :
* = Oxygen, Free Cl, Ozone, Ttl Cl ou Chlrmn ;
** = *, Temp, pH ou GI ;
*** = ** ou Snsr Cur ;
**** = ***, Temp Res ou Not Used ;
***** Unité pour ozone : ppm ou ppb ;
Unité pour chlore (toutes formes) : ppm ;
# : Valable si PV = Free Cl ;
## : Valable si PV = Oxygen ;
### : Valable si PV = Oxygen et unit = %sat ;
#### : Valable si PV = Free Cl, Ttl Cl ou Chlrmn ;
##### : Valable si Dual Range Cal = Enable.
Page 93