Laserworld Diode Série Mode D'emploi page 22

Manual: Diode Series
d) ILDA Streaming
The Laserworld ShowNET interface is capable to act as range extender for ILDA signals by
tranforming an incoming ILDA signal on the ILDA IN interface to a standard UDP network
signal and transferring this signal back to standard ILDA in a receiver unit (obviously an
external ShowNET interface is required as sender for this kind of application!) . Do NOT
send the signal over Wifi, this transmission method is not suitable in a professional envi-
ronment.
Sender-Receiver configuration for ILDA over LAN, range extender use
The sender uses an IP address range between 192.168.2.70 and 192.168.2.85 and trans-
mits the signal to a receiver that has addresses in the range between 192.168.2.50 and
192.168.2.65. The specific IP addresses need to be set with DIP switches. Make sure there
are no other devices in the same network that use the same IP addresses.
Dip switch setting
switch 1
On (1) 0000 -> IP sender: 192.168.2.70 sends to 192.168.2.50
/ Off 0001 -> IP sender: 192.168.2.71 sends to 192.168.2.51
(0) 0010 -> IP sender: 192.168.2.72 sends to 192.168.2.52
0011 -> IP sender: 192.168.2.73 sends to 192.168.2.53
0100 -> IP sender: 192.168.2.74 sends to 192.168.2.54
0101-> IP sender: 192.168.2.75 sends to 192.168.2.55
0110 -> IP sender: 192.168.2.76 sends to 192.168.2.56
0111 -> IP sender: 192.168.2.77 sends to 192.168.2.57
1000 -> IP sender: 192.168.2.78 sends to 192.168.2.58
1001 -> IP sender: 192.168.2.79 sends to 192.168.2.59
1010 -> IP sender: 192.168.2.80 sends to 192.168.2.60
1011 -> IP sender: 192.168.2.81 sends to 192.168.2.61
1100 -> IP sender: 192.168.2.82 sends to 192.168.2.62
1101 -> IP sender: 192.168.2.83 sends to 192.168.2.63
1110 -> IP sender: 192.168.2.84 sends to 192.168.2.64
1111 -> IP sender: 192.168.2.85 sends to 192.168.2.65
Example:
Sender IP address setting:
switch 1
On (1) / Off (0) 0
This assigns IP address 192.168.2.71 to the Sender.
The corresponding receiver needs this IP address setting:
switch 1
On (1) / Off (0) 0
This assigns IP address 192.168.2.51 to the receiver.
The only difference between sender and receiver configuration is dip switch 5, which is 0 for the
sender and 1 for the receiver.
page 19 / 21
2 3
2 3 4
0 0 1
2 3 4
0 0 1
4 5
sender: 0
receiver: 1
5 6 7
0 0 1
5 6 7
1 0 1
6 7 8 9 10
0 1 1 0 0
8 9 10
1 0 0
8 9 10
1 0 0