Heated Handles - Husqvarna 346XP Manuel D'utilisation

Temperature 0° ° ° ° C (32° ° ° ° F) or colder:
The cylinder cover is designed so it can be adjusted for
running in cold weather. Twist the winter flap so that
preheated air from the cylinder can pass into the
carburetor space preventing icing of the air filter, etc.
For temperatures below -5°C and/or in snow conditions
there is also:
• a special cover (A) for the starter housing
• a winter plug (B) for the air nozzle that is fitted as
shown.
These reduce the flow of cooling air and prevent large
amounts of snow from being sucked into the carburetor
space.
CAUTION! When the winter plug is fitted the winter flap
must be open!
IMPORTANT! If the temperature rises above -5°C or 0°C
respectively the machine MUST be restored to its
normal set-up. Otherwise there is a risk of overheating,
which can cause severe engine damage.

Heated handles

(346XPG, 353G)
On models with the designation XPG/G, the front as well
as the rear handle are equipped with electric heating
coils. These are fed with electrical current from an
integrated generator in the chain saw.
MAINTENANCE
When the switch is pushed downwards, the heat is
switched on. When the switch is pushed upwards, the
heat is switched off.
Electrical carburetor heating
(346XPG, 353G)
On models with the designation CARBURETOR
HEATING there is an electrically heated carburetor.
Electrically powered heating prevents ice formation in the
carburetor. A thermostat regulates the heating so that the
carburetor always has the right working temperature.
–
English 37