Interrupting A Programme; Cancelling A Programme; Opening The Door After The Programme Has Started; At The End Of The Programme - AEG L74850 Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Changing a running programme is possible only by resetting it. Turn the
programme selector dial to O/Off and then to the new programme position. The
washing water in the tub will be not emptied out. Start the new programme by
depressing the Start/Pause button again.

Interrupting a programme

Depress the Start/Pause button to interrupt a programme which is running, the
corresponding light starts to flash. Depress the button again to restart the
programme.

Cancelling a programme

Turn the selector dial to O/Off to cancel a programme which is running. Now
you can select a new programme.

Opening the door after the programme has started

First set the machine to pause by pressing the Start/Pause button.
if the «Door»
if the «Door»
heating, that the water level is above the bottom edge of the door. In this
case the door can not be opened.
If you cannot open the door but you need to open it, you have to switch the
machine off by turning the selector dial to O/Off. After about 3 minutes the
door can be opened (pay attention to the water level and
temperature!).

At the end of the programme

The machine stops automatically, the Start/Pause button pilot light goes off, a
flashing
0
appears on the display and the acoustic signal sounds for 2 minutes.
If the Rinse Hold
symbol is still on and the door remains locked to indicate that the water must be
emptied out before opening the door.
To empty out the water please read the steps on the Rinse Hold option
paragraph.
Turn the programme selector dial to O/Off to switch the machine off. Remove
the laundry from the drum and carefully check that the drum is empty.
If you do not intend to carry out another wash, close the water tap. Leave the
door open to prevent the formation of mildew and unpleasant smells.
symbol disappears, the door can be opened.
symbol doesn't go off, it means that the machine is already
or Night Cycle option has been selected, the «Door»
use
73

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

L76850

Table des Matières