Assembly; Operation - Husqvarna LC 142i Manuel D'utilisation

Introduction
WARNING:
product, read the safety chapter.
WARNING:
during assembly, turn the safety key to 0,
remove the battery and wait at minimum 5
seconds.
To assemble the handle
1. Align the holes in the handlebar with the holes in the
lower handle and attach the screws, cable clips and
knobs. Tighten the knobs fully. (Fig. 18)
2. Attach the cables to the handle with the cable clips.
(Fig. 19)
Note:
Make sure that there is not too much
tension in the cables. Too much tension can cause
damage to the cable if the handle is folded into
transport position.
To adjust the handle height
1. Loosen the lower knobs. (Fig. 20)
2. Remove the knob, washer, and screw on the left and
the right side.
3. The handle can be set to 2 different heights. Put the
screw in one of the 2 holes on the left and the right
side. (Fig. 21)
Introduction
WARNING:
product, you must read and understand the
safety chapter.
Husqvarna Connect
Husqvarna Connect is a free app for your mobile device.
The Husqvarna Connect app gives extended functions
for your Husqvarna product:
• Extended product information.
• Information about, and help with, product parts and
servicing.
To start to use Husqvarna Connect
1. Download the Husqvarna Connect app on your
mobile device.
1692 - 002 - 26.11.2021

Assembly

Before you assemble the
To prevent accidental start

Operation

Before you operate the
4. Attach the screws, washers and knobs.
5. Move the knobs up in the direction of the handle until
they stop and you hear a click. Tighten the knobs
fully. (Fig. 22)
To assemble the grass catcher
1. Attach the grass catcher frame to the grass bag with
the rigid part of the bag on the bottom. Keep the
handle of the frame on top of the grass bag. (Fig. 23)
2. Attach the bottom section of the grass catcher frame
in the groove on the bottom of the grass catcher.
3. Attach the grass bag to the grass catcher frame with
the clips. (Fig. 24)
4. Lift the rear cover.
5. Attach the grass catcher to the top edge of the
chassis.
6. Put the lower part of the grass catcher into the grass
discharge channel. (Fig. 25)
To assemble the mulch plug
(accessory)
1. Lift up the rear cover and remove the grass catcher.
2. Put the mulch plug into the discharge channel. (Fig.
26)
3. Replace the blade with the mulch blade that is
supplied in the mulch kit. Refer to
page 20 .
2. Register in the Husqvarna Connect app.
3. Follow the instruction steps in the Husqvarna
Connect app to connect and register the product.
Note:
Husqvarna Connect app is not available for
download in all markets. Speak to your servicing
dealer for more information.
To set the product in operation position
1. Fold the handle rearward. (Fig. 27)
2. Move the lower knobs up in the direction of the
handle until they stop and you hear a click. (Fig. 22)
3. Fold the upper handle fully up. (Fig. 28)
4. Tighten the upper knobs fully.
Technical data on
13