Troubleshooting - IKRA FEM 1200 Manuel D'utilisation

excluded from this warranty. Warranty replacement does
only include defective parts, not complete devices. War-
ranty repair shall exclusively be carried out by authorized
service partners or by the company's customer service.
In the case of any intervention of not authorized person-
nel, the warranty will be held void.
All postage or delivery costs as well as any other subse-
quent expenses will be borne by the customer.

Troubleshooting

Fault
The motor cannot be
started.
Unusual
sounds
Unusually strong
vibration
Bad tilling result
Possible cause
No power
Cable damaged
Safety switch/plug combination
damaged
Overheating protection is activated
Tines are blocked
Lubricating agent is leaking
Screws, nuts or other fastening
elements are loose
Tines are damaged or worn out
Working depth too deep.
Working depth too low.
Worn-out/blunt tines.
Rectification
Check mains supply.
Check cable, pull the plug and insert again,
if required, replace the cable or have it
repaired by a qualified electrician
Have the tool repaired by a specialist
workshop.
1. Working depth too deep, continue work with
less working depth
2. Tines are blocked, remove blocking.
3. Soil is too hard, adapt working depth
accordingly and work soil by repeatedly
moving forward and backward over
the same place.
Let the motor cool down for about 15 minutes
before you resume your work.
Switch the tool off, wait until the motor fully
stops. Eliminate the cause of the blockage.
Have the tool repaired by a specialist
workshop.
Fasten all elements; if the sounds remain
contact a specialist workshop.
Replace the tines or have them checked by a
specialist workshop.
Adjust working depth to a suitable depth.
Adjust working depth to a suitable depth.
Replace the tines or have them checked by a
specialist workshop.
GB-6