Makita 5104 Manuel D'instruction page 9

1
007333
Replacing carbon brushes
001145
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
1
2
008471
After replacing brushes, plug in the tool and break in
brushes by running tool with no load for about 10
minutes. Then check the tool while running and electric
brake operation when releasing the switch trigger. If
electric brake is not working well, ask your local Makita
service center for repair.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
1. Triangular rule
1. Limit mark
1
1. Brush holder
cap
2. Screwdriver
ACCESSORIES
CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Steel & Carbide-tipped saw blades
•
General purpose blade for fast and smooth rip,
Combination
crosscuts and miters.
Pressure treated/ Designed for fast cutting of pressure treated and
Wet lumber wet lumber.
Fine cross cuts For sand-free cuts cleanly against the grain.
006549
Rip fence (Guide rule)
•
Hex wrench
•
9
or attachments
Only use accessory or
are