Preparations; Installation - Julabo TW2 Mode D'emploi

Preparations

 Make sure you read and understand all instructions and safety precautions
listed in this manual before installing or operating your unit.
 Never operate the unit without bath fluid in the bath.
 Prevent water from penetrating into the hot bath oil.
 Do not drain the bath fluid while it is hot!
Check the temperature of the bath fluid prior to draining (by
switching the unit on for a short moment for example).
 Never operate damaged or leaking equipment.
 Always turn off the unit and disconnect the mains cable from the power source
before performing any service or maintenance procedures, or before moving
the unit.
 Always empty the bath before moving the unit.
 Never operate equipment with damaged mains power cables.
 Condensation that could appear in and on other units near the water bath may
result in reduced operating safety.
Be careful when setting up and operating the water bath!
 Some parts of the bath cover may become extremely warm during continuous
operation.
When lifting the bath cover, pay attention to hot steam!
 Be careful when touching these parts!
 Use safety glasses!
6. Preparations
6.1.

Installation

Caution:
The unit is not for use in explosive environment.
36
Place the water bath in an upright position.
>80 mm
Keep a wall distance of minimum 80 mm.