Titan IMPACT 1640 Mode D'emploi page 7

IMPACT 1640
•
Place pump at least 25 feet (7.62 meters) from the spray
object in a well ventilated area (add more hose if necessary).
Flammable vapors are often heavier than air. Floor area
must be extremely well ventilated. The pump contains
arcing parts that emit sparks and can ignite vapors.
•
Plastic can cause static sparks. Never hang plastic to
enclose spray area. Do not use plastic drop cloths when
spraying flammable material.
•
Fire extinguisher equipment shall be present and working.
WARNING: HAZARDOUS VAPORS
Paints, solvents, and other materials can be
harmful if inhaled or come in contact with body.
Vapors can cause severe nausea, fainting, or
poisoning.
PREVENTION:
•
Wear respiratory protection when spraying.
instructions supplied with the mask to be sure it will
provide the necessary protection.
•
All local regulations regarding protection against
hazardous vapors must be observed.
•
Wear protective eyewear.
•
Protective clothing, gloves and possibly skin protection
cream are necessary for the protection of the skin. Observe
the regulations of the manufacturer concerning coating
materials, solvents and cleaning agents in preparation,
processing and cleaning units.
WARNING: GENERAL
This product can cause severe injury or property
damage.
PREVENTION:
•
Always wear appropriate gloves, eye protection, clothing
and a respirator or mask when painting.
•
Do not operate or spray near children. Keep children away
from equipment at all times.
•
Do not overreach or stand on an unstable support. Keep
effective footing and balance at all times.
•
Stay alert and watch what you are doing.
•
Do not operate the unit when fatigued or under the
influence of drugs or alcohol.
•
Do not kink or over-bend the hose. Airless hose can
develop leaks from wear, kinking and abuse. A leak can
inject material into the skin.
Read all
•
Do not expose the hose to temperatures or pressures in
excess of those specified by manufacturer.
•
Do not use the hose as a strength member to pull or lift the
equipment.
•
Use lowest possible pressure to flush equipment.
•
Follow all appropriate local, state and national codes
governing ventilation, fire prevention and operation.
•
The United States Government Safety Standards have
been adopted under the Occupational Safety and Health
Act (OSHA). These standards, particularly part 1910 of
the General Standards and part 1926 of the Construction
Standards should be consulted.
•
Before each use, check all hoses for cuts, leaks, abrasion
or bulging of cover. Check for damage or movement
of couplings. Immediately replace hose if any of those
conditions exist. Never repair a paint hose. Replace with a
conductive high-pressure hose.
•
Do not spray outdoors on windy days.
•
Always unplug cord from outlet before working on
equipment (electric models only).
SAFETY PRECAUTIONS
7