Operation - Ryobi CSB144LZ Manuel D'utilisation

WARNING:
If inner flange bushing has been removed, replace it in
the correct orientation (per markings on the bushing)
before placing blade on spindle. Failure to do so will
prevent blade from tightening properly and could result
in serious personal injury.
 Fit the saw blade inside the lower blade guard and onto
the spindle.
 Replace outer blade washer ("D" washer).
 Replace spring washer with cupped side against "D"
washer.
CALIFORNIA PROPOSITION 65
WARNING:
This product and some dust created by power sanding, sawing, grinding, drilling, and other construction activities may
contain chemicals, including lead, known to the State of California to cause cancer, birth defects, or other reproductive
harm. Wash hands after handling.
Some examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry products and,
• arsenic and chromium from chemically treated lumber.
Your risk from exposure to these chemicals varies, depending on how often you do this type of work. To reduce your
exposure, work in a well-ventilated area and with approved safety equipment, such as dust masks that are specially
designed to filter out microscopic particles.
DANGER:
Keep hands away from cutting area and the blade.
Keep your second hand on auxiliary handle, or motor
housing. If both hands are holding the saw, they cannot
be cut by the blade.
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
ASSEMBLY
 Depress spindle lock button and replace blade screw.
 Tighten blade screw securely by turning it clockwise with
the blade wrench.
NOTE: Never use a blade that is too thick to allow the
outer blade washer ("D" washer) to engage with the flat
on the spindle.
To remove the blade:
 Unplug the saw.
 Depress and hold spindle lock button.
 Remove blade screw by turning it counterclockwise with
the blade wrench, while keeping the spindle lock button
depressed.
 Remove spring washer and then remove outer blade
washer ("D" washer).
 Lift lower blade guard.
 Remove blade.

OPERATION

WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
APPLICATIONS
You may use this product for the purposes listed below:
 Cutting all types of wood products (lumber, plywood,
paneling, composition board, and hard board)
 Cross cutting/rip cutting wood products
 Bevel cutting wood products
 Pocket cutting wood products
8 - English