Kenwood KDC-168U Mode D'emploi page 18

INSTALLATION/CONNECTION
Part list for installation
(A) Faceplate
(B) Trim plate
(C) Mounting sleeve
(D) Wiring harness
(E) Extraction key
18
ENGLISH
Installing the unit (in-dash mounting)
Hook on the top side
Orientate the trim plate as
illustrated before fitting.
When installing without the mounting sleeve
1 Remove the mounting sleeve and trim plate from the unit.
2 Align the holes in the unit (on both sides) with the vehicle mounting
bracket and secure the unit with screws (supplied/commercially available).
Use only the specified screws. Using wrong screws might damage the unit.
How to remove the unit
1 Detach the faceplate.
2 Fit the catch pin on the extraction keys into the holes on both sides of the
trim plate, then pull it out.
3 Insert the extraction keys deeply into the slots on each side, then follow the
arrows as shown on the illustration.
Do the required wiring.
( 19)
Dashboard of your car
Bend the appropriate tabs to hold the
mounting sleeve firmly in place.