References; Maintenance; More Information - Kenwood KDC-168U Mode D'emploi

Masquer les pouces Voir aussi pour KDC-168U:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

TROUBLESHOOTING
Symptom
Remedy
• Switch off the developer options on the Android device.
"NO DEVICE" or
• Reconnect the Android device.
"READING" keeps
• If this does not solve the problem, the connected Android
flashing.
device does not support [BROWSE MODE]. ( 16)
Playback is intermittent
Turn off the power saving mode on the Android device.
or sound skips.
• Reconnect the Android device.
"ANDROID ERROR"/
• Restart the Android device.
"NA DEVICE"
"ADD ERROR"
New station creation is unsuccessful.
"CHECK DEVICE"
Check the Pandora application on your device.
"NO SKIPS"
The skip limit has been reached.
"NO STATIONS"
No stations are found.
"STATION LIMIT"
The number of registered stations has reached its limit.
Retry after deleting unnecessary stations from your device.
"CONNECT ERROR"
Communication is unstable.
"RATING ERROR"
Registration of thumbs up/thumbs down has failed due to
insufficient network connectivity.
"THUMBS N/A"
Registration of thumbs up/thumbs down is not allowed.
"LICENSE ERROR"
You try to access from a country which Pandora is not
deliverable.
Muting upon the reception of a phone call
Connect the MUTE wire to your telephone using a commercial telephone accessory. ( 19)
When a call comes in, "CALL" appears. (The audio system pauses.)
• To continue listening to the audio system during a call, press
and the audio system resumes.
When the call ends, "CALL" disappears. (The audio system resumes.)

REFERENCES

Maintenance

Cleaning the unit
Wipe off dirt on the faceplate with a dry silicone or soft cloth.
Cleaning the connector
Detach the faceplate and clean the connector gently
with a cotton swab, being careful not to damage
the connector.
Handling discs
• Do not touch the recording surface of the disc.
• Do not stick tape etc. on the disc, or use a disc with tape stuck on it.
• Do not use any accessories for the disc.
• Clean from the center of the disc and move outward.
• Clean the disc with a dry silicone or soft cloth. Do not use any solvents.
• When removing discs from this unit, pull them out horizontally.
• Remove burrs from the center hole and disc edge before inserting a disc.

More information

For: – Latest firmware updates and latest compatible item list
– Any other latest information
Visit <www.kenwood.com/cs/ce/>.
General
• This unit can only play the following CDs:
• For detailed information and notes about the playable audio files, visit
<www.kenwood.com/cs/ce/audiofile/>.
. "CALL" disappears
Connector (on the reverse
side of the faceplate)
15
ENGLISH

Publicité

Table des Matières
loading

Table des Matières