Kenwood KDC-168U Mode D'emploi page 12

AUDIO SETTINGS
TRE ADJUST TRE CTR FRQ
TRE LEVEL
PRESET EQ DRIVE EQ/TOP40/POWERFUL/ROCK/POPS/EASY/JAZZ/NATURAL/
USER: Selects a preset equalizer suitable to the music genre. (Select
[USER] to use the settings made in [EQ PRO].)
[DRIVE EQ] is a preset equalizer that reduces noise outside the car or
running noise of the tyres.
BASS BOOST LV1/LV2/LV3: Selects your preferred bass boost level. ;
OFF: Cancels.
LOUDNESS LV1/LV2: Selects your preferred low and high frequencies boost to
produce a well-balanced sound at a low volume level. ;
OFF: Cancels.
SUBWOOFER SET ON: Turns on the subwoofer output. ; OFF: Cancels.
LPF SUBWOOFER THROUGH: All signals are sent to the subwoofer. ;
85HZ/120HZ/160HZ: Audio signals with frequencies lower than
85 Hz/120 Hz/160 Hz are sent to the subwoofer.
SUB-W PHASE REVERSE (180°)/NORMAL (0°): Selects the phase of the subwoofer
output to be in line with the speaker output for optimum performance.
(Selectable only if a setting other than [THROUGH] is selected for
[LPF SUBWOOFER].)
FADER R15 to F15 (0): Adjusts the rear and front speaker output balance.
BALANCE L15 to R15 (0): Adjusts the left and right speaker output balance.
VOLUME OFFSET For AUX: –8 to +8 (0) ; For other sources: –8 to 0: Preset the initial
volume level of each source. (Before adjustment, select the source you
want to adjust.)
12
ENGLISH
10.0KHZ/12.5KHZ/15.0KHZ/17.5KHZ: Selects the
center frequency.
–8 to +8 (+1): Adjusts the level.
SOUND RECNSTR ON: Creates realistic sound by compensating the high-frequency
(Sound components and restoring the rise-time of the waveform that are lost
reconstruction) in audio data compression. ; OFF: Cancels.
• [SUB-W LEVEL]/[SUBWOOFER SET]/[LPF SUBWOOFER]/[SUB-W PHASE] is
selectable only if [SWITCH PREOUT] is set to [SUB-W]. ( 4)
• [SUB-W LEVEL]/[LPF SUBWOOFER]/[SUB-W PHASE] is selectable only if
[SUBWOOFER SET] is set to [ON].