Using The Mains Rectifier - Dometic Waeco CoolPower MPS35 Instructions De Montage Et De Service

Using the mains rectifier

 The place of installation must be well-ventilated. A ventilation system
which is at least equivalent to the air openings in the device must be pre-
sent for installations in closed housings.
 The air intake on the underside or the air outlet on the back of the device
must remain clear.
 The installation surface must be level and sufficiently sturdy.
➤ Fasten the mains rectifier with screws through the fastening holes in the
front and the rear of the device (fig. 1 4, page 3).
7 Using the mains rectifier
WARNING!
!
Do not reverse the polarity. If the poles are reversed device may
overheat and be damaged.
NOTICE!
A
Replace defective fuses with new ones of the same rating (15 A
slow-blow).
WARNING!
!
Protect the positive connecting cable to the battery by an external
fuse of 10 A (fig. 2 4, page 3).
Insert the fuse as near as possible to the battery.
➤ Determine the required cross section of the cable in relation to the cable
length according to fig. 3, page 3.
Key for fig. 3, page 3
Co-ordinate axis
l
∅
18
Meaning
Cable length
Cable cross section
CoolPower MPS35
Unit
m
mm²
EN