Makita 4100NH Manuel D'instruction page 6

FUNCTIONAL DESCRIPTION
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function on
the tool.
Adjusting the depth of cut
007691
Loosen the wing bolt on the depth guide and move the
base up or down. At the desired depth of cut, secure the
base by tightening the wing bolt.
CAUTION:
After adjusting the depth of cut, always tighten the
•
wing bolt securely.
Sighting
007693
Align the edge of the front of the base with your cutting
line on the workpiece.
Switch action
CAUTION:
Before plugging in the tool, always check to see
•
that the switch trigger actuates properly and returns
to the "OFF" position when released.
1
007692
1. Wing bolt
2. Base
1
2
1. Switch trigger
2. Lock-off button
2
To prevent the switch trigger from being accidentally
pulled, a lock-off button is provided. To start the tool,
push in the lock-off button and pull the switch trigger.
Release the switch trigger to stop.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the tool.
Installing or removing diamond wheel
1
2
007695
Hold the outer flange with the wrench and loosen the hex
bolt clockwise with the socket wrench. Then remove the
hex bolt, outer flange and diamond wheel.
To install the wheel, follow the removal procedure in
reverse. Always install the wheel so that the arrow on the
wheel points in the same direction as the arrow on the
blade case.
BE SURE TO TIGHTEN THE HEX BOLT SECURELY.
1
2
007696
CAUTION:
Use only the Makita wrench to install or remove the
•
wheel.
OPERATION
007694
6
1. Wrench
2. Socket wrench
3. Outer flange
4. Diamond wheel
4
3
1. Inner flange
2. Diamond wheel
3. Outer flange
4. Hex bolt
3
4