Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Never use a machine that has a faulty muffler.
Regularly check that the muffler is securely attached to
the machine.
If the muffler on your machine is fitted with a spark
arrestor screen this must be cleaned regularly. A blocked
screen will cause the engine to overheat and may lead to
serious damage.
WARNING! Mufflers fitted with catalytic
!
converters get very hot during use and
remain so for some time after stopping.
This also applies at idle speed. Contact
can result in burns to the skin.
Remember the risk of fire!
WARNING! The inside of the muffler
!
contain chemicals that may be
carcinogenic. Avoid contact with these
elements in the event of a damaged
muffler.
WARNING! Bear in mind that:
!
The exhaust fumes from the engine are
hot and may contain sparks which can
start a fire. Never start the machine
indoors or near combustible material!
34 – English
GENERAL SAFETY PRECAUTIONS
Cutting equipment
The cutter is designed and manufactured to withstand the
loads that edging of a lawn involves.
Check the cutting attachment for damage or cracks. A
damaged cutting attachment should always be replaced.
A non-balanced blade induces heavy vibrations that may
damage the machine.
WARNING! Always stop the engine
!
before you work on any part of the
cutting equipment. This continues to
move even after the throttle is released.
Check that the cutting equipment has
stopped completely and remove the HT
lead from the spark plug before you start
any work on it.
Locking screw
The locking screw secures the cutting attachment on the
output shaft.
Protect your hand from injury when assembling, use the
blade guard as protection when tightening with a socket
spanner.
When fitting, tighten the screw in the opposite direction to
the direction of rotation of the cutting attachment. To
remove it, undo the screw in the same direction as the
cutting attachment rotates. (CAUTION! The screw has a
left-hand thread.)
Tighten the screw using the socket spanner. 35-50 Nm
(3.5-5 kpm).
1155675-32 Rev. 5 2014-12-02
Publicité
Chapitres
Table des Matières
