Technibel Climatisation DSAFM75R5IA Mode D'emploi page 6

F: FILTER button
G: ADDRESS button
H: A/C SENSOR button
I: FLAP button
(inactivated)
CAUTION
(SWEEP)
6
Parts Name and Functions (continued)
If a separately installed signal receiver is being employed, this button is used
to turn off its filter lamp. When the filter lamp has lighted, first clean the filter,
and then press the FILTER button to turn off the filter lamp.
When a wired remote control unit and wireless remote control unit are both
used, the filter sign on the wired remote control unit will be appeared. When
this happens, first clean the filter, and then press the FILTER button on one
of the remote control units to turn off the filter sign.
When a multiple number of indoor units that can be operated by the wireless
remote control unit have been installed in the same room with a multi-unit or
single-unit installation, this button enables addresses to be set in order to
prevent the sending of signals to the wrong indoor unit. Each of up to six
indoor units can be controlled separately using its own wireless remote
control unit by matching the number of the address switch on the operation
area of the indoor unit and the number used for the address of its remote
control unit. (The indoor units cannot be controlled separately when they are
used in a flexible combination format, simultaneous operation of multi units
format or any other such format since they will all operate at the same time.)
When the batteries are replaced, the address setting returns to "ALL", and so
NOTE
please make the setting again.
When you press this button (use a small-tipped object such as a ballpoint
pen), the indication will disappear at the display. And the room
temperature is detected by the sensor which is built in the indoor unit and the
air conditioner is controlled accordingly.
If the remote control is located near a heat source, such as a space heater or
NOTE
in direct sunlight, press the A/C SENSOR button to switch to the sensor on
the indoor unit.
1. Use this button to set the airflow direction to a specific angle.
The airflow direction is displayed on the remote control unit.
Operation mode
(COOL) or
(HEAT) or
(AUTO)
Cooling mode:
Heating mode:
• In the cool mode and dry mode, if the flaps are set in a downward
position, condensation may form and drip around the vent.
• Do not move the flap with your hands.
2. Use this button to make the airflow direction sweep up and down
automatically.
Press this button several times until the
display.
To stop the swing operation
Press the FLAP button again during the flap swing operation to stop the flap
at the desired position. Then, the airflow can be set from the top position by
pressing the FLAP button again.
Number of airflow direction settings
(DRY)
(FAN)
3
5
3
5
symbol appears on the