Cut Off Gauge; Jigs; Making Adjustments; Leveling The Throat Plate - ShopMaster Delta S36-300T2 Guide D'utilisation

CUTTING AIDS AND ACCESSORIES

CUT OFF GAUGE

When crosscutting a number of pieces to the same
length, you can clamp a block of wood (A) (FIGURE 32)
to the fence and use it as a cut-off gauge. The block (A)
must be at least / -inch (19 mm) thick to prevent the cut
3
4
off piece from binding between the blade and the fence.
Once the cut-off length is determined, lock the fence and
use the miter gauge to feed the workpiece into the blade.
Always position the entire cut-off gauge
in front of the saw blade.

JIGS

Jigs may be created with a variety of special set-ups to
control particular workpiece shapes for particular cuts.
Guidance on how to make specialized jigs can be found in
woodworking and carpentry websites and publications.

LEVELING THE THROAT PLATE

Check that the throat plate is properly adjusted to the
table. Front of throat plate should be l
the surface of the table and rear of the throat plate should be
level or slightly above the surface of the table (FIGURE 13).
There are four Phillips set screws pre-assembled to the
table that are used to level the throat plate
If the throat plate is not flush with the surface of the
table, adjust these screws to ensure the entire throat
plate is flush with the table (
MOVING THE SAW
To move the saw firmly grasp the left and right side of the
table. Lift the saw and move to desired location. See example.
Example

MAKING ADJUSTMENTS

evel or slightly below
(FIGURE 14).
FIGURE 14).
DO NOT ATTEMPT TO CREATE
OR USE A JIG UNLESS YOU ARE
THOROUGHLY FAMILIAR WITH TABLE SAW
SAFETY. DO NOT USE ANY JIG THAT COULD
RESULT IN PINCHING A KERF OR JAMMING THE
WORKPIECE BETWEEN THE JIG AND THE BLADE.
INCORRECT SETUPS MAY CAUSE KICKBACK
WHICH COULD RESULT IN SERIOUS INJURY.

CHANGING THE BEVEL

Unlock the bevel lock lever by pulling it into the up
(horizontal) position.
Holding the height adjustment wheel, slide the bevel
indicator to the desired angle.
When the blade is at desired angle, lock the bevel lock
lever by pushing it down (vertical).
NOTE: For lock and unlock positions see FIGURE 34.
23
FIGURE 32
A