General Parts Knowledge; Assembly; Stand Assembly - ShopMaster Delta S36-300T2 Guide D'utilisation

BLADE GUARD
TABLE
SCALE
FENCE RAIL
HEIGHT
ADJUSTMENT
WHEEL
MITER GAUGE
ON/OFF
SWITCH
BEVEL
LOCK
The part and hardware names and letters correspond to those shown in General Parts Knowledge, Shipping Contents, and the
Hardware Contents.
When lifting saw, hold it close to your body while lifting.
Keep knees bent and lift with your legs, not your back.
Fully assemble saw with stand assembly prior to use. Stand
assembly is an integral and necessary part of the support
structure for this saw. Do not attempt to substitute a table or
other surface for the stand assembly. Do not modify saw, or
create accessories not recommended for use with this saw.

STAND ASSEMBLY

Assemble stand part 2 (I) through stand part 1 (H) that has
cross support as shown in (FIGURE 1). Secure stand assembly
with M8 x 65mm hex socket head screw (d), M8 spacer (c), M8
washer (b), and M8 lock nut (e). (FIGURE 1)
M8 spacer (c) is between stand part (H) and (I).
NOTE:
(FIGURE 2) for correct stand parts setup.

GENERAL PARTS KNOWLEDGE

ASSEMBLY

Do not connect to power supply until assembly is complete.
Make sure power switch is in "OFF" position before connecting
to power supply.
Avoid contact with blade teeth. Keep blade stored or lowered
when possible.
I
10
RIVING KNIFE
ANTI-KICKBACK PAWLS
THROAT PLATE
FENCE LOCK
OUTFEED EXTENSION
RIP FENCE
PUSH STICK
BEVEL SCALE
STAND
d
c
H
FIGURE 1
b e