Cold-Starting; Warm-Starting - Makita DPC 6400 Manuel D'instructions Et De Sécurité

CAUTION:
Observe the SAFETY INSTRUCTIONS on page 5!
Start the Power Cut only after complete assembly and
inspection!
Move at least 3m (10 feet) away from the place where you
fuelled the Power Cut.
Make sure you have a good footing, and place the Power
Cut on the ground in such a way that the cutting disc is not
touching anything.
Turn the hood lock (2) to position
Pivot the hood (3) back as far as it will go.
Release the hood lock and pivot the hood lightly back and forth
until the lock engages.

Cold-starting

Move the combination switch (5) up (choke position).
Grasp handle (hand pressure actuates the grip throttle
lever lock (7)).
Push the throttle (8) in all the way and hold it.
Press the throttle lock (6) and release the throttle (8) (the
throttle lock will hold the throttle at half-throttle position).
NOTE: If the Power Cut is installed in the trolley, the control
lever should be in the second arrest position.
Push the starting valve (4).
Grasp the tubular handle firmly with one hand and press the
Power Cut against the ground.
Place the tip of your left foot in the rear handle.
Pull the starter cable strong and rapidly until you hear the first
audible ignition.
CAUTION: Do not pull out the starter cable more than approx.
50 cm (20"), and lead it back by hand.
Press in the starting valve (F/4) again.
Put the combination switch (F/5) in position "I".
Keep pulling the starter cable until the engine catches.
As soon as the engine is running, press the throttle (F/8) to
release the half-throttle lock (F/6), allowing the engine to idle.

Warm-starting

As described under "Cold starting", except without putting the
combination switch (F/5) in choke position.
and hold it there.
2
1
3 meters
(10 feet)
D
3
2
E
4
5
6
7
8
F
G
15