Aligning The Camera - Kompernass WK 8 A2 Mode D'emploi

Aligning the camera

In test mode, you can work out the optimum exposure angle and the
range of the motion sensors
NOTICE
► During alignment, consider whether the use of the side motion
sensors may be useful for attaining the desired observation
results. You can activate/deactivate the side motion sensors
using the above-described menu.
Align the camera as follows:
Fasten the camera to a tree or similar object at a height of 1–2 metres
and align the camera in the desired direction. Then move slowly from
one side of the target area to the other side. Note the information
provided by the LED display
detected by one of the activated side motion sensors
up red, you have been detected by the front motion sensor
Repeat this process to find the best alignment for the camera.
The LED display only lights up when the mode selector switch
the TEST position and one of the motion sensors has detected motion.
During normal operation, there will be no LED display in this case.
To ensure that the camera does not make unwanted recordings of
irrelevant movements, it should not be set up in a sunny location nor
close to branches that can move in the wind. The detection angle
of the sensors is about 100° from corner to corner. The detection
range for photos is approx. 96° on the horizontal plane and 68°
on the vertical. The detection range for videos is approx. 95° on the
horizontal plane and 50° on the vertical.
│ GB │ IE
■ 76
5 6
, .
2
. If this lights up blue, you have been
6
. If it lights
5
.
13
is in
WK 8 A2