Using The Wall Bracket - Kompernass WK 8 A2 Mode D'emploi

Using the wall bracket

You can mount the camera permanently on a wall or ceiling using
the supplied wall bracket. Before mounting the wall bracket you
should ensure that all screws are tight.
CAUTION
► Ensure that there are no electric lines, water or heating pipes
installed at the proposed drilling location!
► The supplied anchors are only suitable for mounting on
concrete or stone. Before starting the installation, please check
your installation location carefully for its suitability for the an-
chors. The assembly material must be suitable for the respective
location. If in doubt, consult a professional.
NOTICE
► During assembly, make sure that you do not mount the camera
upside down. Photos and videos cannot be rotated later.
♦ Mark the drill holes
the desired mounting location and marking the hole positions.
♦ Use a drill with a 6 mm drill bit to drill the required holes and
insert the plugs and insert the anchors
♦ Screw the wall bracket to the wall using the supplied screws
♦ Mount the camera with the tripod thread
21
screw and screw the camera a little way on (about three turns).
♦ Turn the camera in the desired direction and lock it with the lock-
23
ing washer
♦ To move the camera into its final position, undo the two joint
wing screws
by tightening the two joint wing screws.
WK 8 A2
25
by holding the foot of the wall bracket at
.
24
a little, position the camera and fix the position
26
flush with the wall.
9 20
or on the tripod
GB │ IE
27
.
│
75 ■