Imetec N3909 Instructions D'utilisation page 20

The fabric may turn yellow over time. This does not have any effect at all on the safety and/or
effectiveness of the product itself.
Examine the appliance and its supply cord frequently for signs of wear or damage.
EN
lf there are such signs or in the case of malfunction, contact an authorised technical
service centre.
This chapter describes the most common problems that can arise using the appliance. If the problems cannot
be solved with the information below, please contact the Authorised Assistance Centre.
Problem
The LEDs on the control unit do not
light up.
You get a tingling feeling while using
the underblanket.
The symbol lights up even if the
fast pre-heat setting is not activated.
The product has been used
incorrectly or is damaged.
The power cable or another
internal wire is damaged.
The control unit is damaged.
There are holes or tears in the
fabric or stubborn creases that do
not spread out
The packaging of the appliance is made of recyclable materials. Dispose of the packaging in
accordance with the environmental protection regulations.
Pursuant to Directive 2012/19/EU on waste electrical and electronic equipment (WEEE), the
crossed bin symbol on the appliance or its packaging indicates that the appliance must be
disposed of separately from other waste at the end of its useful life.
The user must therefore take the appliance to an appropriate recycling centre for electrical and
electronic equipment. Alternatively, instead of handling the disposal, the user can hand over the
appliance to the retailer when a new, equivalent one is purchased. The user can hand over electronic
products measuring less than 25 cm to retailers of electronic products having a sales area of at least
19
TROUBLESHOOTING
Check that the control unit plug is fully inserted in the socket
(3). If the LEDs remain off, remove the control unit plug from
the socket (3) and return the underblanket to an authorised
technical service centre.
Take the plug out of the socket, then reinsert it with the polar-
ity inverted.
Mark the insertion side for future reference.
Check that the control unit connector (2) is fully inserted in
the underblanket connector (1) and reinsert the plug in the
socket (3). If the
blanket to an authorised technical service centre.
Return the underblanket to an authorised technical
service centre to be checked.
DISPOSAL
Solution
LED does not lights off, return the under-