Imetec N3909 Instructions D'utilisation page 18

• Release the Express fast pre-heat button (9) to deactivate the fast pre-heat function.
The control unit will keep on the last temperature set before activating the fast pre-
heat function or switching OFF.
EN
• Press temperature button (10) to select your preferred all night temperature setting
from 1 to 5. The higher the number, the higher the temperature. The temperature
led (6) will light up on the control unit.
• If the controller is in stand by mode, press the Express fast pre-heat button (9) to
fast pre-heat the bed or press the timer button (8) to select the continuous use
temperatures again.
MEMORY FUNCTION
After using your mattress cover for a few minutes, the control unit will remember your
last temperature setting.
AUTO-OFF FUNCTION
The underblanket has an automatic switch-off function which is activated after 1 hour
or 9 hours. When switched on, the control unit automatically sets to 1 hour on the
auto-off timer and LED 1 lights up in green (7). To change the programming of the
auto-off time, press the timer selector button (8) and select the desired temperature.
When the time has elapsed, the underblanket switches off and the standby LED (11)
lights up in blue.
DISCONNECT
To disconnect your underblanket from the mains, switch the control to OFF position
'O' (12).
The underblanket is washable. Check the washing symbols on the label to ensure it is
washed correctly.
WARNING! Always disconnect the appliance from the mains
and disconnect the control connector from the underblanket
before cleaning or performing maintenance.
BEFORE WASHING
• Take the plug of the control unit cable out of the mains socket (3).
• Press the grip levers at the sides of the control unit connector (2) to remove the control
unit connector from the underblanket connector (1).
MACHINE WASHING
• The underblanket can be cleaned in the washing machine at 40°C, on a delicate cycle.
17
CLEANING AND MAINTENANCE