Electrolux ERN1400AOW Notice D'utilisation page 22

22 www.electrolux.com
Problem
The lamp does not
work.
The compressor op-
erates continually.
Water flows on the
rear plate of the re-
frigerator.
Water flows into the
refrigerator.
Water flows on the
ground.
The temperature in
the appliance is too
low.
The temperature in
the appliance is too
high.
8.1 Replacing the lamp
CAUTION!
Disconnect the plug from the
mains socket.
Possible cause
The lamp is in stand-by.
The lamp is defective.
The temperature is not set
correctly.
The door is not closed
correctly.
The door has been
opened too frequently.
The product temperature
is too high.
The room temperature is
too high.
During the automatic de-
frosting process, frost de-
frosts on the rear plate.
The water outlet is clog-
ged.
Products prevent that wa-
ter flows into the water
collector.
The melting water outlet
does not flow in the evap-
orative tray above the
compressor.
The temperature regulator
is not set correctly.
The temperature regulator
is not set correctly.
Solution
Close and open the door.
Refer to "Replacing the
lamp".
Set a higher temperature.
Refer to "Closing the door".
Do not keep the door open
longer than necessary.
Let the product tempera-
ture decrease to room tem-
perature before storage.
Decrease the room temper-
ature.
This is correct.
Clean the water outlet.
Make sure that products do
not touch the rear plate.
Attach the melting water
outlet to the evaporative
tray.
Set a higher temperature.
Set a lower temperature.