Removing The Grease Filters; Replacing The Carbon Filter; Changing The Light Bulbs - Atag WU5111HM Notice D'utilisation

MAINTENANCE
Grease filters
Lighting
EN 8

Removing the grease filters

Switch off the electricity! Remove the plug from the socket or switch
the electricity off at the mains. Open the panel and pull the special
handle to remove the filter.

Replacing the carbon filter

The carbon filter must always be used if the built in unit is not ducted.
1. Open the panel.
2. Remove the grease filters.
3. Fit the carbon filter by wedging it into the casing (D).
4. Replace the filter grids in the extractor hood.
Note:
• Saturation of the activated charcoal will eventually occur after more
or less prolonged use, depending on the type of cooking and how
frequently the grease filter is cleaned.
• In all cases it is necessary to replace the cartridge at least every
four months.
• DO NOT wash or reuse the carbon filter. Saturated carbon is not
environmentally friendly, change the filter regularly.

Changing the light bulbs

Faulty LEDs must be replaced by a professional installer.