Ryobi RTS21 Manuel D'utilisation page 15

SCREW
MOUNTING THE TABLE SAW BASE TO THE
QUICKSTAND
®
See Figure 8.
 Place the table saw base on the leg stand. Position the
locking knob over the holes in the top of the leg stand.
 Insert the screw on the locking knob into the hole and
turn the locking knob clockwise to secure the table saw
base to the leg stand.
 Repeat with the other three locking knobs.
TO INSTALL THE HANDLE
See Figure 9.
 Hold the nylon nut securely and turn the screw counter-
clockwise to remove the nut completely.
NOTE: Do not remove the screw from the handle.
 Place the nylon nut into the recessed hole on the back of
the height/bevel adjusting handwheel and hold in place.
 Slide the handle and screw into the hole on the height/
bevel adjusting handwheel.
 Using a flathead screwdriver, turn the screw clockwise
and tighten in place.
ASSEMBLY
LOCK NUT
ARROWS
LEG BRACE
Fig. 6
15 - English
HOLE
NUT
WASHER
HEIGHT/BEVEL
ADJUSTING HANDWHEEL
Fig. 7
LOCKING
KNOB
Fig. 8
HANDLE
SCREW
Fig. 9