Minimum Clearances for Servicing
Flue Terminal Size Concentric System
Flue Terminal Size 2-Pipe Flue System
Flue Terminal Protruding
Lift Weight
Dimensions
Gas Connection
Primary Water Content
Air Duct Diameter
Flue Duct Diameter
Supply
Power Consumption
Internal Fuse
Electrode Spark Gap
The electrical specifications of the pump must be as follows:
- 120 V AC; 60 Hz; 10µF; 0.82 A cos f 0.9.
Note:
If the specifications of the installed pump are different, a relay must be wired between the boiler control circuit board
and the pump.
The minimum water flow rate must be as follows:
7.69 gal/min (35.0 l/min).
with a central heating water pressure between 1 and 1.5 bar (14.5 and 21.7 psi).
8.0
7.0
6.0
5.0
4.0
3.0
2.0
7.5
8.5
9.5
Graph 1
INSTALLATION AND SERVICING INSTRUCTIONS
2.4 INSTALLATION
Top
Bottom
Sides
Front
2.5 GENERAL
Height
Width
Depth
2.6 ELECTRICAL
2.7 EXCHANGERS PRESSURE DROP
10.5
11.5
12.5
13.5
14.5
14.2 in / 360.0 mm
9.84 in / 250.0 mm
1.77 in / 45.0 mm
17.71 in / 450.0 mm
6.30 in / 160.0 mm
4.33 in / 110.0 mm
4.52 in / 115.0 mm
215.6 lb / 98.0 kg
37.40 in / 950.0 mm
23.62 in / 600.0 mm
25.60 in / 650.0 mm
1"
4.62 gal USA / 21.0 l
6.30 in / 160.0 mm
4.33 in / 110.0 mm
120 V 60 Hz
5116 Btu /h - 150 W
F 3.15 A
0.13 in to 0.17 in. / 3.5 to 4.5 mm
3.5
3.0
2.5
2.0
1.5
1.0
7.5
8.5
9.5
8
10.5
11.5
12.5
13.5
14.5
7110243.01 - en