Attaching The Belts; Transport - Thomashilfen EASyS Modular S Manuel De L'utilisateur

User manual – EASyS Modular S seat unit
Headrest
Insert the tube of the headrest into the receiver at the top of the headrest bracket and tighten the wing screw. (Fig. 23)
The headrest can be adjusted without fixed increments by loosening the knurled screws on the rear of the backrest.
(Fig. 24) To adjust the angle of the headrest, loosen the wing screws at the headrest bracket. (Fig. 25) In addition, the
headrest can be adjusted in depth by loosening the wing screw on top of the headrest bracket. (Fig. 26) The angle of the
headrest surface is adjustable both vertically and horizontally by loosening the screws of the ball joint. (Fig. 27)
The angle of the lateral parts of the adjustable headrest can be adjusted. To vary the angle, open the cover of the head-
rest in order to to loosen the screws in the hinges by using an Allen wrench.
Make sure to retighten all screws when adjustments are completed.
Lower leg length
The grub screws on the side of the footrest can be loosened using the Allen wrench (SW 3; Fig. 28). Now the footrest
can be adjusted infinitely. Then the grub screws must be retightened.
Foot angle
Loosen the four screws on the right and left of the underside of the footrest, adjust the desired foot angle, and then
retighten the screws. You will need a 10 mm box wrench or combination wrench (Fig. 29).
Knee angle
Set the knee angle by loosening the red eccentric lever on both knee joints (Fig. 5).
TIP: The footrest can be folded up to simplify getting into and out of the stroller.

Attaching the belts

Depending on the size of the child, guide the two upper belts through the openings in the cushioning and insert them
through the slots in the frontmost back plate (Fig. 30). Then guide the belts into the buckles and adjust the desired belt
length (Fig. 31).
The two bottom ends of the belts can be attached with buckles to the rear of the back plate or to the plastic element on
the side (Figs. 32-33). Guide the belts to the left and right of the backrest upholstery and continue to the corresponding
buckle, and then fasten them.
The front belts of the 4-point lap belt are attached to the seat side element on the right and left sides using a buckle.
Open the zipper of the lateral seat upholstery, guide the belt through the slot in the seat side guide, insert it into the
buckle, and fasten it (Figs. 34-35). Close the zipper of the lateral seat upholstery.
TIP: In addition, the belt length can be adjusted at the front; to do so, pull on the D-ring to shorten the belt.

Transport

The EASyS Modular S seat unit, together with the A chassis Advantage, can be folded up for transport in a vehicle trunk.
Heed the instructions for folding the rehab wagon and use the lock for folding to avoid unintentional unfolding.
The seat unit and chassis can be separated so that their weights can be lifted separately. In this regard, please refer to
the instructions for removing the seat unit.
To ensure the simplest possible handling, use one hand to grab the seat unit by the handle on the headrest tubes, to
which the release lever for the seat tilting is also attached (Fig. 1). With the other hand, grab the front edge of the seat.
19