Parking Brake Function; Parking Brake Function For The Front Wheels; Attaching The Belts; Tip Assist - Thomashilfen Swifty 2 Manuel De L'utilisateur

User manual – Swifty 2
Sun and rain cover holders
The Swifty 2 is equipped with holders for a sun and rain cover as standard. (Fig. 14) The sun and rain cover itself is
available as an accessory.
Adjustment options
Backrest adjustment
Loosen the clamping lever on the back, adjust the desired hip angle by sliding the back bow on the back rail, and re-
tighten the lever. (Fig. 15)
Lower leg length
Unscrew the Allen keys (3 mm) on the right and left rear of the footrest tube guides. Move the footrest to the desired
position by sliding it on the frame tube and tighten the screws again. (Fig. 16)
Footrest
The footrest can be folded upwards to make it easier for children to get into the buggy. (Fig. 17)

Parking brake function

To lock the brake, place your foot on the brake bow and push it down. Release the brake by placing your foot under the
brake bow and pulling it upwards. (Fig. 18)

Parking brake function for the front wheels

Tightening: Turn the front wheel so that it is straight and let the locking latch bolt snap in (it clicks audibly).
Releasing: Pull out the locking latch bolt and lock it with a 90° rotation. (Fig. 19)

Attaching the belts

Using the stitched seams, undo the back pads depending on the required height of attachment.
Guide the two upper belts through the openings in the pad and insert them through the slots in the back plate. (Fig. 12)
Open the zipper at the back of the back pads and then insert the belts into the folding buckles and adjust the desired
belt length. (Fig. 13) The two lower ends of the belt can be fastened to the back of the back plate using folding buckles.
(Fig. 20) Guide the straps to the right and left of the back pad and secure them. Close the back pad again. (Figs. 6-7)
TIP: The belt length can also be adjusted at the front. To do this, pull the D-ring to shorten the belt.
The front belts of the 4-point pelvis belt are attached on the right and left under the seat using a folding buckle. Guide
the belt between the side guide and the seat plate, insert it into the folding buckle, and tighten it. (Figs. 21-22)
Tip assist (accessory)
Place your foot on the tip assist, hold the rehab stroller with both hands, and tip it. (Fig. 23)

Transport

The Swifty 2 rehab stroller can be folded up for transport in a vehicle trunk. Heed the instructions for folding the rehab
stroller use the folding lock to avoid unintentional unfolding.
The Swifty 2 rehab stroller can be lifted on the side parts of the frame or on the rear axle.
22