DeWalt DCS355 Guide D'utilisation page 13

2. Align the edges on the sanding
sheet, with the edge of the sanding
platen and press the sanding sheet
(L) onto the platen.
3. Firmly press the base with the
sanding sheet attached against a flat
surface and briefly switch the tool
on. This provides for good adhesion
between the platen and the sanding
sheet and also helps to prevent
premature wear.
4. When the tip of the sanding sheet
becomes worn, detach the sheet from the platen, rotate and
reapply.
ATTACHING ACCESSORIES USING THE UNIVERSAL
ADAPTER (FIG. 7)
Non-D WALT accessories can be
e
attached using the universal adaptor.
1. Place the washer (M) on the tool.
2. Place accessory on to washer.
3. Tighten and secure adaptor nut (N)
using hex wrench.
CAUTION: To avoid injury, do not
use any accessory for an application
where the adaptor may fail to hold the
accessory.
CAUTION: Read and follow all manufacturers' safety warnings for
any accessories used with this tool.
CAUTION: To avoid injury, ensure adaptor and accessory are
securely tightened.
Attaching the Cut Guide (Fig. 8–12)
FIG. 6
The depth/cut guide allows you to precisely
L
cut material at a specified depth or height and
more accurately track a marked cut line.
1. Attach the cut guide block (F) by inserting
2. Secure the block to the main body with
K
DEPTH GUIDE
This feature allows you to precisely cut
material at a specified depth.
1. Insert the guide arm (G) as shown in
FIG. 7
2. Adjust the length of the guide by pulling out or pushing inward to
M
N
3. Secure the guide in place by turning the depth/cut adjustment
11
the tabs (O) on the guide into the
accessory side mount (E) on the main
body of the tool.
the supplied screw (Q) and washer (S).
Tighten with the supplied hex wrench (R).
Figure 9 into the front slot on the guide
block (F).
achieve the desired cut depth as shown in Figure 10.
knob (P) clockwise. To release the guide, turn the depth/cut
adjustment knob counterclockwise.
FIG. 9
F
G
FIG. 8
E
O
S
F
Q
R
FIG. 10
P