Fritel SR 3150 Mode D'emploi page 12

all these cases return the appliance to your sales point or authorized after sales
service.
• After use always remove the plug from the socket. Also proceed this way when the
appliance is not in use, before cleaning and moving. Therefore, NEVER pull the
cord, but only the plug.
• NEVER use separate timers or remote control systems.
• Use the appliance only what it is intended for, namely baking food on the salt stone and having raclette in the pans
under the grill. The appliance can never be used for other purposes or be combined with other appliances.
• ALWAYS place the appliance on a heat-proof, solid and flat base, such as a kitchen counter or table, so that the
appliance won't move or turn over.
• NEVER use extension cords or sockets. Place the appliance near a power point and connect it directly. ALWAYS
completely unroll the power cord.
• NEVER let the cord hang over the edge of the table or counter.
• NEVER use the plug to lift or move the appliance. Never fold, clamp the cord or never turn it round the appliance or
never pull it over a sharp edge.
• NEVER place the cord near heat sources such as cookers, heatings or ovens.
• NEVER place the appliance near curtains, wall decoration, clothing, towels or other inflammable objects.
• NEVER cover the appliance when it is working.
• NEVER use accessories from other appliances.
• NEVER put inflammable or heat conductive objects on the salt stone, like for example a kitchen towel, kitchen paper,
cutlery, ...
• This appliance is NOT suited for flambé.
• This appliance is NOT to be used with charcoal or other propellants.
• NEVER pour cold water on the salt stone as long as it is hot.
• Leave enough space around the appliance, min. 0,5m around and 1 m above, to avoid damage because of the heat or
splashes and to be able to work freely.
• The appliance may also be used outdoor, on the following conditions:
* The power cord should regularly be examined for signs of damage. If this is the case, do not use the appliance
anymore, but immediately return it to your sales point.
* The appliance must be connected to a socket-outlet having an earthed contact 230V.
* The appliance must be supplied through a residual current device (RCD) having a rated residual operating current
not exceeding 30 mA.
• Only use the appliance on the mains voltage as indicated on the identification label.
• The appliance may only be used if the stone has been placed correctly.
• Repairs can only be done by an approved technician or by an approved service center.
2. BEFORE THE FIRST USE
• Check if the mains voltage of your appliance (230 Volt) corresponds with the mains voltage in your home.
• Remove all packaging and stickers.
• Place the salt stone and the pans on/in the appliance.
• Turn on the appliance and let it heat up for about 10 minutes.
ATTENTION: Upon the first use, there might be a slight odor or smoke output. This is normal and will disappear by
itself.
• Turn off the appliance again, pull the cord from the socket.
• Let the appliance cool down completely.
Attention: never cool down the salt stone under cold running water. Because of the temperature difference small
cracks can appear on the salt stone or the salt stone could burst.
12