Jydepejsen Bella Mode D'emploi page 25

Sheet iron wood-burning stoves may produce a crackling sound during the kindling and cooling stages. This is normal for
sheet iron stoves and is not a defect.
DuplicAir®
The stove is fitted with a DuplicAir® air wheel - a customized air controlling system that regulates kindling and combustion
air. DuplicAir® is operated by means of a handle on the front of the stove.
Use of DuplicAir®
The air wheel has the following settings and functions:
1. The handle in position 1 (fully to the left): both combustion air and kindling air are closed.
2. The handle in position 2: combustion air is 50% open.
3. The handle in position 3: combustion air is fully open.
4. The handle in position 4 (fully to the right): both combustion air and kindling air are fully open.
This setting may be used for a short while during kindling only.
Once the wood has caught fire, the handle should be placed in position 3 or less (to the left) depending on the heat
requirement.
The handle may also be placed between the settings. You should not turn it down so much that the fire dies. Flames should
be visible in the fire chamber at all times.
Note! The stove and the chimney react differently in cold, respectively, warm weather and on
windy, respectively, quiet days. Hence, you should adjust the air flow.
Start-up stage
1. Place the air wheel in position 4.
2. Place firelighters and kindling on the bottom of the fire chamber.
3. Place approx. 1.2kg kindling in the shape of a matchstick house.
4. Light the fire.
5. The door to the fire chamber should be left open for the first few minutes.
6. Once the wood has caught fire, move the handle to position 3
or less (to the left.) Close the door.
7. Just how much closure is required depends of the up-draft in the chimney
and the heat requirement.
Stoking
This wood-burning stove is intermittent, meaning that fresh wood is required for stoking once an adequate layer of embers
has been achieved on the fire chamber floor. The heat requirement determines the amount of stoking, and the level of
stoking depends of the season. In order to ensure optional combustion, use 3 0,7 kg. logs, approx.30 cm in length which
are placed side by side on top of the embers from the kindling process. This will give you a combustion time of approx. 45
minutes.
It is important to keep the door closed when flames are visible in the fire chamber to avoid smoke nuisances in the
room.
1. Move the air wheel handle to position 4 (maximum air supply.)
2. To minimize the negative pressure, the door to the fire chamber should be ajar for about 1 minute before it is fully
opened.
3. Open the door slowly.
4. Place 3 0,7 kg. logs (30 cm in length) next to each other on top of the embers.
5. Close the door again.
6. Once the wood has caught fire, the handle should be moved to position 3 or lower. You have achieved healthy
combustion when the flame is steady and almost transparent.
DuplicAir® operating handle