Dörr DAF-44 Wi Notice D'utilisation page 10

Nomenclature
Reflecting Plate
Diffuser Plate
Flash Head
Battery Compartment
Lid
Wireless Sensor
Slave Sensor
AF- Red Light
Metal Base
②
Information on LC Display
1. F-Stop Indicator
2. Zoom Position Indicator (Focal Length)
3. Flash Mode Indicator
4. Flash Power Indicator for Manual Flash Mode
5. Flash Range Indicator
6. Power OFF - Standby Mode Indicator
Preface
Thank you for purchasing a DÖRR zoom flash. The flash unit is designed for the usage with
digital cameras with TTL flash control. Before using the DÖRR DAF-44 Wi for the first time, we
recommend to read this manual carefully so that you can benefit from all functions of your new
flash. Please also adhere to the indications for flash photography in the instruction manual for
your camera.
Important Information
Before using the DÖRR DAF-44 Wi, please pay attention to the following safety instructions:
• In case of failure, do not attempt to disassemble the flash yourself as there is high voltage
circuitry inside. In case the flash proves to be defective, send it to your local dealer or
service agent of your country. In case the flash should break, make sure not to touch the
inside elements.
• The flash is a technical precision device that can be damaged by impacts and other ungentle
handling.
• This flash is not weatherproofed. It should be protected from rain and excessive humidity to
avoid irreparable damage.
• Be sure to protect the flash from high temperatures. Never leave it in the car exposed to
direct sunlight. Avoid extreme temperature fluctuations.
• Never clean the flash with gasoline or other strong detergents.
10
④
③
Mounting Foot with Lock Ring
Socket for
Firmware Update
Panel on Rear Side of Flash
⑤
①
⑥
Mounting Foot with
Lock for Model
Sony- Alpha
Mounting Foot
for Models:
Canon / Nikon /
Pentax- Samsung /
Olympus- Panasonic
MODE ZOOM
READY
TTL OK
/TEST
OFF ON
Type C, N, OP, SA
MODE ZOOM
READY
TTL OK
/TEST
OFF
Type P
GB