Description Of Footbath; Operation - Beurer FB 12 Mode D'emploi

Handling
CAUTION
• Switch the device off and disconnect the power supply after every use and before every
cleaning.
• Keep the device away from high temperatures.
• Never stand in the foot bath.
• The device must not be connected to the power supply while being filled.
• Always switch the foot bath off and remove the plug from the mains socket before moving it
or cleaning it.

4. Description of footbath

1
3
7
6
5

5. Operation

Start-up
• Remove the packaging
• Check the device, power supply and cables for damage.
• Before you plug in the foot bath, fill it up to the fill-level mark (approx 4 cm full) with either warm or
cold water. The foot rest should, however, be completely covered with water.
• Route the cable safely so that there is no risk of anyone tripping over it.
• Place the foot bath on a firm and level surface.
Make yourself comfortable in a chair and place your feet on the foot rest and apply slight pressure.
Never stand up in the foot bath. The rubber feet on the base of the unit prevent it from sliding.
Switch on the device. To do this, press the function button [2].
The vibration massage, bubble massage and maintains water temperature control are started simultaneously.
Massage attachment
The massage attachment in the middle provides a comfortable massage for your feet and stimulates
the circulation. This can be removed for cleaning purposes.
2
8
4
11
1. Splash protection
2. Function button
3. Fill-level mark
4. Bubble bar
5. Massage attachment
6. Rubber feet (on underside of device)
7. Foot rest with massage nodules
8. Draining outlet