Machine Models; Marking Data - John Bean T 8058 Manuel D'utilisation

18
1.4-1
1.4-2
1.4-3
Safety
1.4

Machine models

This manual relates to three machine models which
are very similar but have some structural and functional
differences.
Figure 1-4.1
shows the machine Model B, with the control unit
(pedal unit) connected to the machine by a cable.
Figure 1-4.2
shows the machine Model BA, with the control unit
mounted on the articulated arm.
Figure 1-4.3
shows machine Model WL, with the control unit (pedal
unit) connected to the machine by a radio frequency
transceiver and automatic tool repositioning device
from one side to the other of the wheel (side-to-side).
Note:
The machines have identical operation, except
for the positioning and use of the controls
which
may differ from one model to the next. See
section
4.1 Controls.

1.5 Marking data

A marking label attached to the machine shows the
following data:
- Name and address of the manufacturer
- Compliance marking
- Year of manufacture
- Model
- Serial number
- Weight
- Electric specifi cations (volt, ph, Hz, kW and A)
- Required Pressure
- Acustic pressure
Operator's Manual
John Bean T 8058