English - i-tec C31MYSAFEM2 Mode D'emploi

i-tec MySafe USB-C M.2 SSD External Case
SPECIFICATION
• External USB-C case for M.2 B-Key SATA Based
SSD discs
• Transferrable interface: 1x USB-C 3.1, Gen. 2 (up
to 10Gbps)
• Compatible with M.2 B-Key SATA Based SSD discs
with sizes 2230, 2242, 2260, 2280
• Plug & Play function
• Active LED diode indicating the case state (lights –
is connected, twinkles – record/reading is going
on)
• Power supply 5V, 900mA
• Weight: 44 g
• Dimensions: 110 x 40 x 9 mm
SYSTEM REQUIREMENTS
Windows 7/8/8.1/10 32/64bit, macOS 10.x and higher –
automatic installation of drivers from the system. A free
USB-C port.
M.2 DISC HARDWARE INSTALLATION
Go on according to the following instructions:
1. Screw out 2 pcs of screws on the connector side of
the case and take off the cover.
2. Take out the motherboard.
3. Insert M.2 disc so that the slot in the disc
corresponds to the slot on the M.2 connector. After
that, screw up the M.2 disc on the opposite side to
the motherboard. Insert the motherboard together
with the M.2 disc back and screw up the pair of
the screws.
4. Connect a USB cable to the case. Now the device is
ready for using.
SOFTWARE INSTALLATION
Windows 7/8/8.1/10 32/64bit or macOS 10.x and higher
After connecting the device to a computer, detection
6 |

ENGLISH